Table of Contents
Advertisement
Quality of Service (QoS) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Command Mode
Policy-map Class Configuration mode.
User Guidelines
This command is only available when QoS is in advanced mode.
A frame is mirrored in the same format if it matches to one of the class ACLs
regardless the command of this ACL: permit or deny.
Only one source session from VLAN and flow mirroring is supported.
The analyzer Ethernet port is configured by the
command with the same session number.
Example
The following example creates an ACL, places it into a class map, places the class
map into a policy map and mirrors the flow to an analyzer Ethernet port defined by
session 2:
switchxxxxxx(config)# ip access-list extended ip1
switchxxxxxx(config-ip-al)# permit ip any any
switchxxxxxx(config-ip-al)# exit
switchxxxxxx(config)# class-map c1
switchxxxxxx(config-cmap)# match access-group ip1
switchxxxxxx(config-cmap)# exit
switchxxxxxx(config)# policy-map p1
switchxxxxxx(config-pmap)# class c1
switchxxxxxx(config-pmap-c)# mirror 2
switchxxxxxx(config-pmap-c)# exit
switchxxxxxx(config-pmap)# exit
switchxxxxxx(config)#
monitor session destination
47
930
Advertisement
Table of Contents
