Qos Map Dscp-Queue - Cisco Sx350 Cli Manual

47
951
•
dscp-list
—Specifies up to 8 DSCP values, separated by spaces. (Range: 0–
63)
•
dscp-mark-down
Default Configuration
The default map is the Null map, which means that each incoming DSCP value is
mapped to the same DSCP value.
Command Mode
Global Configuration mode
User Guidelines
The original DSCP value and policed-DSCP value must be mapped to the same
queue in order to prevent reordering.
Example
The following example marks incoming DSCP value 3 as DSCP value 5 on the
policed-DSCP map.
switchxxxxxx(config)#

47.28 qos map dscp-queue

Use the qos map dscp-queue Global Configuration mode command to configure
the DSCP to queue map. Use the no form of this command to restore the default
configuration.
Syntax
qos map dscp-queue
no qos map dscp-queue [
Parameters
•
dscp-list—Specifies up to 8 DSCP values, separated by spaces. (Range: 0–
63)
—Specifies the DSCP value to mark down. (Range: 0–63)
qos map policed-dscp
dscp-list to queue-id
dscp-list
]
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Quality of Service (QoS) Commands
3 5
to