Dot1X Timeout Tx-Period - Cisco Sx350 Cli Manual

3
107
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The default value of this command should be changed only to adjust to unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
The command is only applied to the 802.1x authentication method.
Example
The following example sets the time interval during which the device waits for a
response to an EAP request frame from the client before resending the request to
3600 seconds.
switchxxxxxx(config)#
switchxxxxxx(config-if)#

3.25 dot1x timeout tx-period

To set the time interval during which the device waits for a response to an
Extensible Authentication Protocol (EAP) request/identity frame from the client
before resending the request, use the dot1x timeout tx-period command in
Interface Configuration mode. To restore the default configuration, use the no form
of this command.
Syntax
dot1x timeout tx-period
no dot1x timeout tx-period
Parameters
•
seconds
—Specifies the time interval in seconds during which the device
waits for a response to an EAP-request/identity frame from the client before
resending the request. (Range: 30–65535 seconds).
Default Configuration
The default timeout period is 30 seconds.
interface gi11
dot1x timeout supp-timeout
seconds
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
802.1X Commands
3600