IPv6 Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
switchxxxxxx(config)#
Example 3. The following example deletes all static entries in the IPv6 neighbor
discovery cache on VLAN 1:
switchxxxxxx(config)#
Example 4. The following example deletes all static entries in the IPv6 neighbor
discovery cache on all interfaces:
switchxxxxxx(config)#
28.25 ipv6 policy route-map
To enable policy routing on an interface and identify a route map, use the ipv6
policy route-map command in Interface Configuration mode. To disable policy
routing, use the no form of this command.
Syntax
ipv6 policy route-map
no ipv6 policy route-map
Parameters
•
map-tag
—Name of the route map to use for policy routing. The name must
match a map-tag value specified by a
Default Configuration
No policy routing occurs on the interface.
Command Mode
Interface Configuration mode
User Guidelines
Use the ipv6 policy route-map command to enable IPv6 policy routing.
no ipv6 neighbor 2001:0DB8::45A vlan1
no ipv6 neighbor vlan1
no ipv6 neighbor
map-tag
route-map (Policy Routing)
28
command.
582