Bridge Multicast Forbidden Forward-All - Cisco Sx350 Cli Manual

Address Table Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
Forwarding of all Multicast packets is disabled.
Command Mode
Interface (VLAN) Configuration mode
Example
The following example enables all Multicast packets on port gi14 to be forwarded.
switchxxxxxx(config)#
switchxxxxxx(config-if)#

4.16 bridge multicast forbidden forward-all

To forbid a port to dynamically join Multicast groups, use the bridge multicast
forbidden forward-all Interface (VLAN) Configuration mode command. To restore
the default configuration, use the no form of this command.
Syntax
bridge multicast forbidden forward-all {add | remove} {ethernet
port-channel-list
port-channel
no bridge multicast forbidden forward-all
Parameters
•
add—Forbids forwarding of all Multicast packets.
•
remove—Does not forbid forwarding of all Multicast packets.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
—Specifies a list of port channels. Separate
interface vlan 2
bridge multicast forward-all add gi14
}
—Specifies a list of Ethernet ports. Separate
4
interface-list |
144