Table of Contents
Advertisement
12
291
•
prefix-length
—Specifies the number of bits that comprise the address
prefix. The prefix is an alternative way of specifying the client network
mask. The prefix length must be preceded by a forward slash (/).
•
low-address
low
range.
•
high-address
high
range.
Default Configuration
DHCP address pools are not configured.
If the low address is not specified, it defaults to the first IP address in the network.
If the high address is not specified, it defaults to the last IP address in the network.
Command Mode
DHCP Pool Network Configuration mode
Example
The following example configures the subnet number and mask for a DHCP
address pool on a DHCP server.
switchxxxxxx(config-dhcp)#
12.3 auto-default-router
To enable auto default router, use the auto-default-router command in DHCP Pool
Network Configuration mode or in DHCP Pool Host Configuration mode. To disable
auto default router, use the no form of this command.
Syntax
auto-default-router
no auto-default-router
Parameters
N/A
—Specifies the first IP address to use in the address
—Specifies the last IP address to use in the address
address
10.12.1.0 255.255.255.0
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
DHCP Server Commands
Advertisement
Table of Contents
