Ipv6 Multicast Hop-Threshold - Cisco Sx350 Cli Manual

30
721
switchxxxxxx(config)#

30.2 ipv6 multicast hop-threshold

To configure the Hop Limit threshold of packets being forwarded out an interface,
use the ipv6 multicast hop-threshold command in Interface Configuration mode.
To return to the default Hop Limit threshold, use the no form of this command.
Syntax
ipv6 multicast hop-threshold
no ipv6 multicast hop-threshold
Parameters
•
hop-value
—Hop Limit value. It can be a value from 0 to 256.
Default Configuration
The default Hop Limit value is 0.
Command Mode
Interface Configuration mode
User Guidelines
Multicast packets with a hop value less than the threshold will not be forwarded on
the interface.
The default value of 0 means all Multicast packets are forwarded on the interface.
A value of 256 means that no Multicast packets are forwarded on the interface.
You should configure the hop threshold only on border routers. Conversely, routers
on which you configure a hop threshold value automatically become border
routers.
Example
The following example sets the Hop Limit threshold on a border router to 200:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
ipv6 multicast-routing mld-proxy
hop-value
interface vlan 100
ipv6 multicast hop-threshold 200
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
IPv6 IPM Router Commands