Macro Auto Trunk Refresh - Cisco Sx350 Cli Manual

Smartport Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
16. port security discard trap 60
17. #
18. smartport storm-control broadcast level 10
19. smartport storm-control include-multicast
20. smartport storm-control broadcast enable
switchxxxxxx(config)#

55.10 macro auto trunk refresh

The macro auto trunk refresh Global Configuration command reapplies the
Smartport macro on a specific interface, or to all the interfaces with the specified
Smartport type.
Syntax
macro auto trunk refresh [
Parameters
•
smartport-type
•
interface-id
—Interface Identifier (port or port channel).
Default Configuration
See User Guidelines.
Command Mode
Global Configuration mode
User Guidelines
The macro auto smartport command becomes effective only when the Auto
Smartport is globally enabled.
smartport-type
If both
is executed on the interface if it has the given Smartport type.
smartport-type
If only
interfaces having the given Smartport type.
smartport-type
] [
—Smartport type (switch, router, wireless access point (ap))
interface-id
and are defined, the attached Smartport macro
is defined, the attached Smartport macro is executed on all
interface-id
]
55
1070