Power Over Ethernet (Poe) Commands; Power Inline - Cisco Sx350 Cli Manual

Power over Ethernet (PoE) Commands

Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
45.0

45.1 power inline

To configure the inline power administrative mode on an interface, use the power
inline Interface Configuration mode command.
Syntax
power inline auto [ time-range
never
power inline
Parameters
•
auto—Turns on the device discovery protocol and applies power to the
device.
•
never—Turns off the device discovery protocol and stops supplying power
to the device.
•
time-range-name—Specifies a time range. When the time range is not in
effect the power is not supplied the attached device. If a time range is not
specified, there is no time range bounded to the port. (Range: 1–32
characters)
Default Configuration
The default configuration is set to auto.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
The never parameter cannot be used with a time range.
time-range-name]
45
891