Show Radius Server Statistics - Cisco Sx350 Cli Manual

Radius Server Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide

49.20 show radius server statistics

To display the Radius server counters, use the show radius server statistics
command in User EXEC mode.
Syntax
show radius server statistics [
Parameters
•
ip-address
—Specifies the RADIUS client host IP address. The IP address
can be an IPv4, IPv6 or IPv6z address.
Command Mode
User EXEC mode
User Guidelines
Use the show radius server statistics command to display the Radius server
counters defined in RFC4669 and RFC4671.
Use the show radius server statistics command without parameter to display the
global counters.
Use the show radius server statistics command with parameter to display the
counters of the given NAS.
Examples
Example 1. The following example displays the Radius server global counters:
switchxxxxxx#
show radius server statistics
Number of incoming packets on the authentication port: 120
Number of incoming Access-Requests from unknown addresses: 0
Number of duplicate incoming Access-Requests: 3
Number of sent Access-Accepts: 100
Number of sent Access-Rejects: 17
Number of sent Access-Challenges: 0
Number of incoming malformed Access-Requests: 0
ip-address
]
49
996