Negotiation - Cisco Sx350 Cli Manual

17
389
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example configures gi11 to operate in full duplex mode.
switchxxxxxx(config)#
switchxxxxxx(config-if)#

17.8 negotiation

To enable auto-negotiation operation for the speed and duplex parameters and
master-slave mode of a given interface, use the negotiation Interface (Ethernet,
Port Channel) Configuration mode command. To disable auto-negotiation, use the
no form of this command.
Syntax
capability
negotiation [
no negotiation
Parameters
•
Capability—(Optional) Specifies the capabilities to advertise. (Possible
values: 10h, 10f, 100h,100f, 1000f ).
-
10h—Advertise 10 half-duplex
-
10f—Advertise 10 full-duplex
-
100h—Advertise 100 half-duplex
-
100f—Advertise 100 full-duplex
-
1000f—Advertise 1000 full-duplex
•
Preferred—(Optional) Specifies the master-slave preference:
-
Master—Advertise master preference
-
Slave—Advertise slave preference
interface gi11
duplex full
capability2 capability5
[ ...
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Ethernet Configuration Commands
preferred master
]] [ {
slave
| }]