Ipv6 Dhcp Relay Destination (Global) - Cisco Sx350 Cli Manual

DHCPv6 Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
ipv6 dhcp duid-en 9 0CC084D303000912
Example 2. The following sets the DIID-EN format using colons as delimiter:
switchxxxxxx(config)#

14.6 ipv6 dhcp relay destination (Global)

To specify a globally-defined relay destination address to which client messages
are forwarded, use the ipv6 dhcp relay destination command in Global
Configuration mode. To remove a relay destination address, use the no form of this
command.
Syntax
ipv6 dhcp relay destination {
no ipv6 dhcp relay destination [{
Parameters
•
ipv6-address
[
documented in RFC 4291 where the address is specified in hexadecimal
using 16-bit values between colons. There are the following types of relay
destination address:
-
Link-local Unicast address. A user must specify the
argument for this kind of address.
-
Global Unicast IPv6 address. If the
the Routing table is used.
•
interface-id
—Interface identifier that specifies the output interface for a
destination. If this argument is configured, client messages are forwarded to
the well-known link-local Multicast address
All_DHCP_Relay_Agents_and_Servers (FF02::1:2) through the link to which
the output interface is connected.
Default Configuration
There is no globally-defined relay destination.
ipv6 dhcp duid-en 9 0C:C0:84:D3:03:00:09:12
ipv6-address
ipv6-address
interface-id
]—Relay destination IPv6 address in the form
interface-id interface-id
[ ]} |
interface-id interface-id
[ ]} |
interface-id
interface-id
argument is omitted then
14
]
354