Ip Igmp Last-Member-Query-Count; Ip Igmp Last-Member-Query-Interval - Cisco Sx350 Cli Manual

21
IGMP Commands

21.2 ip igmp last-member-query-count

To configure the Internet Group Management Protocol (IGMP) last member query
counter, use the ip igmp last-member-query-count command in Interface
Configuration mode. To restore the default value, use the no form of this command.
Syntax
count
ip igmp last-member-query-count
no ip igmp last-member-query-count
Parameters
count—The number of times that group- or group-source-specific queries are sent
upon receipt of a message indicating a leave. (Range: 1–7)
Default Configuration
A value of IGMP Robustness variable.
Command Mode
Interface Configuration mode
User Guidelines
Use the ip igmp robustness command to change the IGMP last member query
counter.
Example
The following example changes a value of the IGMP last member query counter to
3:
switchxxxxxx(config)# interface vlan 1
switchxxxxxx(config-if)# ip igmp last-member-query-count 3
switchxxxxxx(config-if)# exit

21.3 ip igmp last-member-query-interval

To configure the Internet Group Management Protocol (IGMP) last member query
interval, use the ip igmp last-member-query-interval command in Interface
467 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide