Ipv6 Hop-Limit - Cisco Sx350 Cli Manual

IPv6 Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Default Configuration
IPv6 interface is disabled.
Command Mode
Interface Configuration mode
User Guidelines
This command automatically configures an IPv6 link-local Unicast address on the
interface while also enabling the interface for IPv6 processing. The no ipv6 enable
command does not disable IPv6 processing on an interface that is configured with
an explicit IPv6 address.
Example
The following example enables VLAN 1 for the IPv6 addressing mode.
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#

28.9 ipv6 hop-limit

Use the ipv6 hop-limit command in Global Configuration mode to configure the
maximum number of hops used in all IPv6 packets that are originated by the router.
To return the hop limit to its default value, use the no form of this command.
Syntax
ipv6 hop-limit value
no ipv6 hop-limit
Parameters
•
value
—Maximum number of hops. The acceptable range is from 1 to 255.
Default Configuration
The default is 64 hops.
interface vlan 1
ipv6 enable
exit
28
560