Lldp Med Notifications Topology-Change - Cisco Sx350 Cli Manual

36
767
Example
The following example enables LLDP MED with the location TLV on gi13.
switchxxxxxx(config)#
switchxxxxxx(config-if)#

36.7 lldp med notifications topology-change

To enable sending LLDP MED topology change notifications on a port, use the lldp
med notifications topology-change Interface (Ethernet) Configuration mode
command. To restore the default configuration, use the no form of this command.
Syntax
lldp med notifications topology-change
no lldp med notifications topology-change
Parameters
•
enable—Enables sending LLDP MED topology change notifications.
•
disable—Disables sending LLDP MED topology change notifications.
Default Configuration
Disable is the default.
Command Mode
Interface (Ethernet) Configuration mode
Example
The following example enables sending LLDP MED topology change notifications
on 2.
gi1
switchxxxxxx(config)#
switchxxxxxx(config-if)#
Link Layer Discovery Protocol (LLDP) Commands
interface gi13
lldp med enable location
{enable | disable}
interface gi12
lldp med notifications topology-change enable
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide