Table of Contents
Advertisement
28
603
Example
The following is sample output from the show ipv6 route summary command:
switchxxxxxx#
show ipv6 route summary
IPv6 Routing Table Summary - 97 entries
37 local, 35 connected, 25 static
Number of prefixes:
/16: 1, /28: 10, /32: 5, /35: 25, /40: 1, /64: 9
/96: 5, /112: 1, /127: 4, /128: 36
28.36 show ipv6 static
Use the show ipv6 static command in user EXEC or privileged EXEC mode to
display the current static routes of the IPv6 routing table.
Syntax
ipv6-address
show ipv6 static [
interface-id
][detail]
Parameters
•
ipv6-address
—Provides routing information for a specific IPv6 address.
This argument must be in the form documented in RFC4293 where the
address is specified in hexadecimal using 16-bit values between colons.
•
ipv6-prefix
—Provides routing information for a specific IPv6 network. This
argument must be in the form documented in RFC4293 where the address
is specified in hexadecimal using 16-bit values between colons.
•
prefix-length
/
—Length of the IPv6 prefix. A decimal value that indicates
how many of the high-order contiguous bits of the address comprise the
prefix (the network portion of the address). A slash mark must precede the
decimal value.
•
interface-id
interface
•
detail—Specifies for invalid routes, the reason why the route is not valid.
ipv6-prefix
prefix-length
|
/
—Identifier of an interface.
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
IPv6 Commands
] [interface
Advertisement
Table of Contents
