Lacp System-Priority; Lacp Timeout - Cisco Sx350 Cli Manual

Link Aggregation Control Protocol (LACP) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide

35.2 lacp system-priority

To set the system priority, use the lacp system-priority Global Configuration mode
command. To restore the default configuration, use the no form of this command.
Syntax
lacp system-priority
no lacp system-priority
Parameters
value—Specifies the system priority value. (Range: 1–65535)
Default Configuration
The default system priority is 1.
Command Mode
Global Configuration mode
Example
The following example sets the system priority to 120.
switchxxxxxx(config)#

35.3 lacp timeout

To assign an administrative LACP timeout to an interface, use the lacp timeout
Interface (Ethernet) Configuration mode command. To restore the default
configuration, use the no form of this command.
Syntax
{long | short}
lacp timeout
no lacp timeout
Parameters
•
long—Specifies the long timeout value.
value
lacp system-priority 120
35
756