Show Rate-Limit Interface; Show Rate-Limit Vlan - Cisco Sx350 Cli Manual

50
1007

50.5 show rate-limit interface

To display rate limit configuration on an interface, use the show rate-limit interface
command in Privileged EXEC mode.
Syntax
show rate-limit interface [
Parameters
•
interface-id
—(Optional) Specifies an Ethernet port. If the argument is not
configured rate limit configuration of all Ethernet ports is displayed.
Default Configuration
N/A
Command Mode
Privileged EXEC mode
Examples
The following is an example of the output from the show rate-limit interface:
switchxxxxxx>
show rate-limit interface
Interface Rate Limit (kbps)
------------ ----------------------
-
gi11gi12
80000
100000

50.6 show rate-limit vlan

To display rate limit configuration on a VLAN, use the show rate-limit vlan
command in Privileged EXEC mode.
Rate Limit and Storm Control Commands
interface-id ]
Burst (Bytes)
----------------
-
512
1024
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide