Snmp-Server Enable Traps - Cisco Sx350 Cli Manual

43
879
Example
The following example displays the SNMP engine ID.
switchxxxxxx# show snmp engineID
Local SNMP engineID: 08009009020C0B099C075878
IP address Remote SNMP engineID
----------- -------------------------------
172.16.1.1 08009009020C0B099C075879

43.18 snmp-server enable traps

To enable the device to send SNMP traps, use the snmp-server enable traps
Global Configuration mode command. To disable all SNMP traps, use the no form
of the command.
Syntax
snmp-server enable traps
no snmp-server enable traps
Default Configuration
SNMP traps are enabled.
Command Mode
Global Configuration mode
User Guidelines
If no snmp-server enable traps has been entered, you can enable failure traps by
using snmp-server trap authentication
Example
The following example enables SNMP traps except for SNMP failure traps.
switchxxxxxx(config)#
switchxxxxxx(config)#
Network Management Protocol (SNMP) Commands
as shown in the example.
snmp-server enable traps
no snmp-server trap authentication
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide