Iscsi Flow - Cisco Sx350 Cli Manual

32
737
Example
The following example enables iSCSI QoS globally
switchxxxxxx(config)#

32.2 iscsi flow

To define an iSCSI flow, use the iscsi flow command in Global Configuration mode.
To remove the iSCSI flow, use the no form of the command.
Syntax
tcp-port
iscsi flow default | {
no iscsi flow [default | {
Parameters
•
default—Restores the default IPv4 flows.
•
tcp-port
—Specifies the TCP port number on which iSCSI targets listen to
requests. (Range: 1–65535)
•
ip-address
—Specifies the IPv4 address on which iSCSI targets listen to
requests.
Default Configuration
Two iSCSI IPv4 flows with well-known TCP ports 3260 and 860.
Command Mode
Global Configuration mode
User Guidelines
Each iscsi flow command defines an iSCSI flow including the following two
sub-flows:
:
iscsi enable
ip-address
[ ]}
tcp-port ip-address
[ ]}]
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
iSCSI QoS Commands