Qos Cos - Cisco Sx350 Cli Manual

Quality of Service (QoS) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
no qos trust
Parameters
N/A
Default Configuration
Each port is enabled while the system is in basic mode.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
Example
The following example configures gi11 to the default trust state.
switchxxxxxx(config)#
switchxxxxxx(config-if)# qos trust

47.31 qos cos

Use the qos cos Interface (Ethernet, Port Channel) Configuration mode command
to define the default CoS value of a port. Use the no form of this command to
restore the default configuration.
Syntax
default-cos
qos cos
no qos cos
Parameters
default-cos—Specifies the default CoS value (VPT value) of the port. If the port is
trusted and the packet is untagged, then the default CoS value become the CoS
value. (Range: 0–7)
Default Configuration
The default CoS value of a port is 0.
interface gi11
47
954