Bridge Multicast Ipv6 Mode - Cisco Sx350 Cli Manual

4
135
4.9

bridge multicast ipv6 mode

To configure the Multicast bridging mode for IPv6 Multicast packets, use the
bridge multicast ipv6 mode Interface (VLAN) Configuration mode command. To
return to the default configuration, use the no form of this command.
Syntax
bridge multicast ipv6 mode {mac-group | ip-group | ip-src-group}
no bridge multicast ipv6 mode
Parameters
•
mac-group—Specifies that Multicast bridging is based on the packet's
VLAN and MAC destination address.
•
ip-group—Specifies that Multicast bridging is based on the packet's VLAN
and IPv6 destination address for IPv6 packets.
•
ip-src-group—Specifies that Multicast bridging is based on the packet's
VLAN, IPv6 destination address and IPv6 source address for IPv6 packets.
Default Configuration
The default mode is mac-group.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
Use the mac-group mode when using a network management system that uses a
MIB based on the Multicast MAC address.
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Address Table Commands