Ipv6 Icmp Error-Interval - Cisco Sx350 Cli Manual

28
561
Command Mode
Global Configuration mode
Example
The following example configures a maximum number of 15 hops for all IPv6
packets that are originated from the router:
switchxxxxxx(config)#

28.10 ipv6 icmp error-interval

Use the ipv6 icmp error-interval command in Global Configuration mode to
configure the interval and bucket size for IPv6 ICMP error messages. To return the
interval to its default setting, use the no form of this command.
Syntax
ipv6 icmp error-interval
no ipv6 icmp error-interval
Parameters
•
milliseconds
—Time interval between tokens being placed in the bucket.
Each token represents a single ICMP error message. The acceptable range
is from 0 to 2147483647. A value of 0 disables ICMP rate limiting.
•
bucketsize
—Maximum number of tokens stored in the bucket. The
acceptable range is from 1 to 200.
Default Configuration
The default interval is 100ms and the default bucketsize is 10 i.e. 100 ICMP error
messages per second.
Command Mode
Global Configuration mode
ipv6 hop-limit 15
milliseconds bucketsize
[
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
IPv6 Commands
]