Table of Contents
Advertisement
14
359
switchxxxxxx(config-if)#
Example 5. The following example disables DHCPv6 relay on VLAN 100:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
14.8 show ipv6 dhcp
To display the Dynamic DHCP unique identifier (DUID) on a specified device, use
the show ipv6 dhcp command in User EXEC mode.This information is relevant for
DHCPv6 clients and DHCPv6 relays.
Syntax
show ipv6 dhcp
Parameters
NA
Command Mode
User EXEC mode
User Guidelines
This command uses the DUID, which is based on the link-layer address for both
client and server identifiers. The device uses the MAC address from the
lowest-numbered interface to form the DUID.
Examples
Example 1. The following is sample output from this command when the switch's
DUID format is vendor based on enterprise number:
switchxxxxxx#
show ipv6 dhcp
The switch's DHCPv6 unique identifier(DUID)is 0002000000090CC084D303000912
exit
interface vlan 100
no ipv6 dhcp relay destination
exit
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
DHCPv6 Commands
Advertisement
Table of Contents
