Ipv6 Mld Robustness; Ipv6 Mld Version - Cisco Sx350 Cli Manual

MLD Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide

40.6 ipv6 mld robustness

To configure the Multicast Listener Discovery (MLD) robustness variable, use the
ipv6 mld robustness command in Interface Configuration mode. To restore the
default value, use the no form of this command.
Syntax
ipv6 mld robustness
no ipv6 mld robustness
Parameters
•
count
—The number of expected packet loss on a link. Parameter range.
(Range: 1–7).
Default Configuration
The default value is 2.
Command Mode
Interface Configuration mode
User Guidelines
Use the ipv6 mld robustness command to change the MLD robustness variable.
Example
The following example changes a value of the MLD robustness variable to 3:
switchxxxxxx(config)# interface vlan 1
switchxxxxxx(config-if)# ipv6 mld robustness 3
switchxxxxxx(config-if)# exit

40.7 ipv6 mld version

To configure which version of Multicast Listener Discovery Protocol (MLD) the
router uses, use the ipv6 mld version command in Interface Configuration mode.
To restore the default value, use the no form of this command.
count
40
828