Ipv6 Dhcp Guard Policy - Cisco Sx350 Cli Manual

IPv6 First Hop Security
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Example
In the following example, the DHCPv6 Guard policy policy1 is attached to VLAN
100:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#

29.16 ipv6 dhcp guard policy

To define a DHCP Guard policy and place the switch in DHCPv6 Guard Policy
Configuration mode, use the ipv6 dhcp guard policy command in Global
Configuration mode. To remove the DHCPv6 guard policy, use the no form of this
command.
Syntax
ipv6 dhcp guard policy
no ipv6 dhcp guard policy
Parameters
•
policy-name
—The DHCPv6 Guard policy name (up to 32 characters).
Default Configuration
No DHCPv6 Guard policy are configured
Command Mode
Global Configuration mode
User Guidelines
This command defines the DHCPv6 Guard policy name, and places the router in
DHCPv6 Guard Policy Configuration mode.
The following commands can be configured in IPv6 DHCP Guard Policy
Configuration mode:
•
device-role (IPv6 DHCP Guard)
interface vlan 100
ipv6 dhcp guard attach-policy policy1
exit
policy-name
policy-name
29
626