Table of Contents
Advertisement
ACL Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
An access-list entry consists of an IP address and a bit mask. The bit mask is a
number from 1 to 128.
Evaluation of an IPv6 address by an access list starts with the first entry of the list
and continues down the list until a match is found. When the IPv6 address match is
found, the permit or deny statement is applied to that address and the remainder
of the list is not evaluated.
Use the no ipv6 access-list command to delete the access list.
The IPv6 standard access list is used to filter received and sent IPv6 routing
information.
Example
The following example of an access list allows only the one specified prefix: Any
IPv6 address that does not match the access list statements will be rejected.
switchxxxxxx(config)# ipv6 access-list 1 permit 3001::2/64
Note: all other access implicitly denied.
2
80
Advertisement
Table of Contents
