Authentication Open - Cisco Sx350 Cli Manual

802.1X Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Example
The following example sets the 802.1X authentication mode to RADIUS server
authentication. Even if no response was received, authentication succeeds.
switchxxxxxx(config)#
3.2

authentication open

To enable open access (monitoring mode) on this port, use the authentication
open command in Interface Configuration mode. To disable open access on this
port, use the no form of this command.
Syntax
authentication open
no authentication open
Parameters
This command has no arguments or keywords.
Default Configuration
Disabled.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
Open Access or Monitoring mode allows clients or devices to gain network
access before authentication is performed. In the mode the switch performs
failure replies received from a Radius server as success.
Example
The following example enables open mode on interface gi11:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
aaa authentication dot1x default radius none
interface gi11
authentication open
3
82