Ip Igmp Robustness; Ip Igmp Version - Cisco Sx350 Cli Manual

21
471

21.6 ip igmp robustness

To configure the Internet Group Management Protocol (IGMP) robustness variable,
use the ip igmp robustness command in Interface Configuration mode. To restore
the default value, use the no form of this command.
Syntax
count
ip igmp robustness
no ip igmp robustness
Parameters
•
count
—The number of expected packet loss on a link. Parameter range.
(Range: 1–7).
Default Configuration
The default value is 2.
Command Mode
Interface Configuration mode
User Guidelines
Use the ip igmp robustness command to change the IGMP robustness variable.
Example
The following example changes a value of the IGMP robustness variable to 3:
switchxxxxxx(config)# interface vlan 1
switchxxxxxx(config-if)# ip igmp robustness 3
switchxxxxxx(config-if)# exit

21.7 ip igmp version

To configure which version of Internet Group Management Protocol (IGMP) the
router uses, use the ip igmp version command in Interface Configuration mode. To
restore the default value, use the no form of this command.
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
IGMP Commands