Table of Contents
Advertisement
SP2-xxx Drum
2959
Display VDB ID
This SP displays the 8-bit data that identifies the FPGA version of the VDB
(Video Drive Board). The VDB controls the signals sent to the LPH.
5.8.1 TEST PATTERN PRINTING
The following procedure will provide information to access various test patterns and to
enable test patterns printing.
1.
Open the roll feeder drawer and cut off a sheet manually from a roll. (Turn the manual
feed knob to feed the paper, then push the cutter from side to side to cut.) Close the
roll feeder drawer.
2.
Go into the Copy SP. mode.
3.
Select SP2902-1, SP2902-2 or SP2902-3 and then select a test pattern (from those
listed in section 5 of the service manual) then press OK.
4.
Touch COPY Window. to go to the main screen.
5.
On the operation panel, select one of the rolls for paper feed.
6.
Put the blank sheet of paper on the original feed tray and feed it into the original feed
unit. The pattern selected prints.
7.
Touch SP Mode to return to the SP mode list. Then press 0: None and select OK
before selecting a different set of patterns or exiting out of the SP mode.
B286/B289
5-72
SM
Advertisement
Table of Contents
Troubleshooting
