Ricoh B286 Service Manual page 74

Roll Feeder (B851/B852)
5. Remove the rear plate [1] of the roll feeder (" x 2).
6. Remove the metal brackets [2], [3] (" x 1 each). Discard these brackets and screws.
7. Remove the shipping tape from the roll feeder harnesses between the bottom of the
main machine and top of the roll feeder.
8. Route the harness (# x 1) through bracket [4] then attach the bracket (" x 2). (Use
one screw from the accessories.)
9. Route the harness (# x 2) through bracket [5] and then attach the bracket (" x 2).
(Use one screw from the accessories).
10. Connect the left harness [1] to CN103 on the PSU (# x 1, & x 1).
11. Connect the right harness [2] to CN220 and CN221 on the MCU (# x 2, & x 3).
B286/B289 1-38 SM