Table of Contents
Advertisement
!
"Available Settings" is not displayed until Step 2 is done. If this setting is not
selected, tell the customer that this setting must be selected before you can
do the installation procedure.
Seal Check and Removal
1.
Turn off the main power switch and disconnect the power supply cord.
2.
Check the two box seals [1] on the corners of the box.
!
Make sure that the seals are attached at both corners.
!
The surfaces of the tapes must be blank.
!
If you see "VOID" on the tapes, do not install the components in the box, contact
your sales division.
3.
If the surfaces of the tapes do not show "VOID", remove them from the corners of the
box.
!
Do not install the application if you see "VOID." The "VOID" marks [2] become
visible only after the tape is removed. This guarantees that the box has not
been opened since it was shipped.
Installation
!
Before doing the procedure, turn off the main power switch and unplug the
machine from its power source.
1.
Make sure that the machine is switched off and disconnected from its power source.
2.
Disconnect the network cable.
3.
Turn the main power switch on.
4.
Turn the operation switch and main power switch off.
SM
Installation of MFP Options
1-73
B286/B289
Advertisement
Table of Contents
Troubleshooting
