Using The Sp Mode; Direct Entry; Normal Direct Entry - Ricoh B286 Service Manual

5. SERVICE TABLES

5.1 USING THE SP MODE

5.1.1 DIRECT ENTRY

Normal Direct Entry

1. Go into the SP mode.
Push [Clear] (").
!
! Push [1] [0] [7].
! Push and hold [Clear/Stop] (#) for 3 seconds.
The initial SP mode screen appears.
2. Touch "Copy SP."
3. When the SP mode is opened it is in direct entry mode (SP Direct). Input the full
number of the SP code. Then push [#].
When you input the number:
! Do not input a hyphen (-) between the first 4 digits and the last 3 digits.
nd
! If the 2 half of the SP code is only 1 or 2 digits, input the zeros that are in front.
For example, if the 2
If you input only the first 4 digits of an SP that has sub levels, the first SP code
!
(001) will be shown. Push the key below "PrevMenu" or "NextMenu" to show the
SP. Then push the key below "Set" or push [#].
4. Set the adjustment value.
If a minus sign (-) is necessary, push ( to change the +/- sign.
!
! If a decimal point is necessary, do not push the decimal point button. For example,
SM
nd
number is 1 or 12, push [0] [0] [0] or [0] [1] [2].
5-1
Using the SP Mode
B286/B289