Sp Table Key - Ricoh B286 Service Manual

5.6 SP TABLE KEY

Notation
[range/default step]
DFU
Not Used
Japan Only
! Always turn the machine power off/on after changing an SP setting.
SM
What it means
Example: [-9 to +9/+3.0/0.1 mm step]. Setting can be adjusted
in the range ±9, value reset to +3.0 after and NVRAM reset,
and the value can be changed in 0.1 mm steps with each key
push.
"Design or Factory Use." Do not change this value. The factory
default setting provides optimum performance.
These SP's appear in the SP mode menus but these codes are
not used because:
! Currently the feature is not available for the main machine,
or its use has been discontinued.
! The SP is intended for use with a peripheral that is
currently under development but not available at this time.
Note: Executing these SP's has no effect on operation of the
main machine or any peripheral device.
This feature or item is for Japan only. Do not change this value.
5-21
SP Table Key
B286/B289