Ricoh B286 Service Manual page 396

SP5-xxx Mode
5821 Remote Service Address (Japan Only)
1 CSS PI Device Code
2 RCG IP Address
NVRAM Data Upload
Uploads the UP and SP mode data (except for counters and the serial
5824
number) from NVRAM on the control board to a flash memory card.
While using this SP mode, always keep the front cover open. This prevents
a software module accessing the NVRAM during the upload.
NVRAM Data Download
5825
Downloads the content of a flash memory card to the NVRAM on the control
board.
5828 Network Setting
65 Job Spool Setting
Switches job spooling spooling on and off.
0: No spooling 1: Spooling enabled
66 Job Spool Clear
This SP determines whether the job interrupted at power off is resumed at the
next power on. This SP operates only when SP5828065 is set to 1.
1: Resumes printing spooled jog.
0: Clears spooled job.
B286/B289
Sets the PI device code. After changing this
setting, you must switch the machine off and
on.
Sets the IP address of the RCG (Remote
Communication Gate) destination for call
processing at the remote service center.
[00000000h to FFFFFFFFh/ 00000000h /
5-126 SM