12. Reattach:
[1] Shield cover (" x 8)
!
!
[2] Ground plate (" x3)
!
Roll feeder rear plate(# x 2)
!
When you reattach the ground plate, make sure that the harness wires [3]
below are not pinched between the bottom of the frame and bottom of the
ground plate.
13. Reattach:
!
Controller box cover
!
Rear cover
!
Open and close the paper exit cover C1 and paper exit unit C2 together to
confirm that the rear cover is installed correctly. If the paper exit cover does
not open properly, remove the rear cover and install it again.
SM
Roll Feeder (B851/B852)
1-39
B286/B289