Sp1-Xxx Feed - Ricoh B286 Service Manual

SP1-xxx Feed

5.7 SP1-XXX FEED
1001 Leading Edge Registration
st
1 1 Roll
nd
2 2 Roll
3 Cassette
5 By-pass Feed
1002 Side-to-Side Registration
st
1 1 Roll
nd
2 2 Roll
3 Cassette
5 By-pass Feed
1105 Fusing Temperature Adjustment
Be sure to switch the main power switch off and on after adjustment.
1 Copy Ready Temperature
B286/B289
Adjusts the leading edge registration for printing. To move the
image down the page, increase the value.
[-10.0 to +10.0/ 0 /0.1 mm step]
Adjusts the side-to-side registration for printing.
[-10.0 to +10.0/ 0 /0.1 mm step]
! To move the start position to the right, increase the
value (+).
To move the start position to the left, decrease the
!
value (–).
Note: If you use paper 914 mm wide, adjust within the
range of ±2 mm. If you set the adjustment outside this
range, part of the image will be cut off.
Sets the copy ready fusing temperature. The
setting is the difference from the target fusing
temperature that is set with SP1931. DFU
[0 to +20/10/1°C]
Copying can start at this temperature before
the hot roller reaches its target temperature
(SP1931).
5-22 SM