Set the Operation Panel Position
You can adjust the position of the operation panel to decrease bright reflections from the
operation panel display..
1.
Lift or lower the operation panel [1] to one set of the three sets of holes to set the panel
at the desired angle.
2.
Push each anchor screw [2] into its hole (" x 3).
!
It is not necessary to tighten the screws.
Setting the Main Machine on the Roll Feeder (B851/B852) or Table
(B854)
1.
Do not remove the shipping tape from the connectors [1] of the roll feeder [2]. This
prevents damage to the connectors when the main machine is put on top of the roll
feeder.
SM
Main Machine Installation (B286)
1-9
B286/B289