Scanner Layout - Ricoh B286 Service Manual

Original exit rollers [F]: Feed the original out while the scanned image is processed
Upper output tray [G]: Receives the original after scanning. Long originals will curl in the
tray.
! If the original output trays are removed, the original feeds in a straight path, out of
the rear of the machine. The original feed path through the machine is the same.
The user should remove the original output trays when scanning thick originals so
!
the original will feed straight out.
Scanner motor [H]: Controls the original feed roller and original exit roller. (See section
6.2.4 "Original Drive Mechanism.")

6.2.2 SCANNER LAYOUT

[A]: Original Width Sensors. Detect the width of the original.
[B]: Original Set Sensor. Detects when the original is put on the original feed table.
[C]: Original Feed Roller. Feeds the original to the original registration sensor.
[D]: Original Registration Sensor. Detects the leading edge of the original and stops feed
temporarily for the user to align the original manually.
[E]: CIS. Scans the original and sends the image data to the VDB.
[F]: Original Exit Sensor. Detects the leading and trailing edge of the original for job timing.
[G]: Original Exit Roller. Feeds the original out of the machine.
SM 6-9
Scanner
B286/B289