Rapid Direct Entry - Ricoh B286 Service Manual

Using the SP Mode
to input "-1.3", push ( for the minus sign, then push [1] [3].
If you make an error, push # to reset the setting, then try again. You cannot
!
correct it with a new entry.
5. Push the key below "Set" on the LCD, or push [#] to enable the setting you have just
input.
6. To go out of SP mode, push the key on the operation panel below "Exit" one or more
times until you see the initial copy screen.
7. Switch the main power switch off. Then switch it on again.
! You must switch the main power switch off then on again to enable the SP codes
that you have just input.

Rapid Direct Entry

1. Refer to the "Service Tables" in this section to find the SP code.
2. Go into the SP mode.
! Push [Clear] (").
! Push [1] [0] [7].
! Push and hold [Clear/Stop] (#) for 3 seconds.
3. Input the group number. Then input the full number to go directly to the SP code
screen. It is not necessary to stop until the screens show.
Examples
[1] (Copy) [2001002]
[1] (Copy) [2001]
B286/B289
Shows the setting screen for SP2001-2.
Shows the setting screen for the first level below
SP2001 (1).
Note: To see the level before or after, push "PrevMenu"
or "NextMenu." With SP2001-xxx on the display, input
the full number again to go directly to 2001-2.
5-2 SM