Ricoh B286 Service Manual page 486

SP8-xxx Data Log 2
8381 T:Total PrtPGS
8382 C:Total PrtPGS
8384 P:Total PrtPGS
8385 S:Total PrtPGS
8386 L:Total PrtPGS
8387 O:Total PrtPGS
838x 1 Field Number
838x 2 Length (High)
838x 3 Length (Low)
838x 4 Area (High)
838x 5 Area (Low)
Note:
! The values for "Length" are displayed in mm. If a "Length" reading is
"42126" this is 42,126 mm (42.126 m).
! The values for "Area" are displayed as mm
"33213257" this is 33,213,257 mm
The counts for the "Length" and "Area" start with "Low." Once the
!
count exceeds the width of the field on the display the "Low" field will
reset to "0" and the count overflows to the "High" SP codes. (This is
necessary because the fields of the "Low" SP codes are limited to 8
digits and not wide enough to display the full reading for a reading
larger than 8 digits.)
! Always check the "Low" SP first. If the "Low" display is zero, check the
"High" field.
! When the length count reaches "99,999,999" in the "Low" field (8
digits), for example, after the next copy the count will show "1" in the
"High" field and "00 000 000" in the "Low." Multiply the "1" in the "High"
field by: 1) 10
kilometers) to determine the accurate count.
B286/B289
These SP's count the number of pages printed by
the operator. The counter for the application used
for storing the pages increments.
[0 to 99 999 999/ 0 / 1]
The L: counter counts the number of pages stored
from within the document server mode screen at
the operation panel. Pages stored with the Store
File button from within the Copy mode screen go to
the C: counter.
Total number of copies (regardless of size)
Total length
Total length
Total area coverage
Total area coverage
8
" (100,000,000 mm), 2) 10
5-216
2
. If an "Area" reading is
2 2
(33,213.257 m ).
5
(100, 000 m) or 3) 10
2
(100
SM