Step 10: Scanner Registration; Step 11: Printer: Cut Length - Ricoh B286 Service Manual

SP Adjustments

Step 10: Scanner Registration

1. Use the A1 LEF Test Chart to make a 1:1 copy on plain A1 LEF paper.
2. On the copy, measure the gap between the chart image and the leading edge and left
edge.
3. Adjust these SPs if necessary:
SP Standard
4010-1 ±3 mm
4011 ±2.8 mm

Step 11: Printer: Cut Length

The following SPs are necessary for this step:
SP
1920-111 Cut Length Adjustment-1
1920-115 Cut Length Adjustment-1
1920-211 Cut Length Adjustment-2
1920-215 Cut Length Adjustment-2
! The cut length adjustment is done for all paper sizes after these settings are done.
! After these settings are done you may still need to do fine adjustments for each
paper size.
! SP1920-1 to 238 (Cut Length Adjustment)
1. Use the Preset Cut feature to make standard cuts of plain paper for these sizes:
Size
A3 Sideways
A1 Lengthways
B286/B289
Scanner Sub Scan Reg – Leading Edge
Scanner Main Scan Reg
st
st
nd
nd
Orientation
Comments
Roll:297 mm (11" or 12"):Plain Paper
Roll:1189 mm (44" or 48"):Plain Paper
Roll:297 mm (11" or 12"):Plain Paper
Roll:1189 mm (44" or 48"):Plain Paper
3-76 SM