Ricoh D131 Service Manual page 1392

Safety Instructions for this Machine
1. The installation must be done by trained service technicians.
2. This machine weighs 316 kg. (695 lb.). At least four persons are required to remove the
machine from its pallet and position it for installation.
3. To prevent fire hazards never use flammable solvents around the machine.
4. Never place any object on the machine.
5. If anything falls into the machine, turn off the main power switch on the right side of the
machine, then disconnect the power cord from the power source.
6. Locate the machine on a sturdy flat surface where it will not be exposed to excessive
vibration.
7. To avoid fire hazard, confirm that the ventilation ports are not blocked, so air can flow
freely.
8. Gas generated by the molten glue can irritate the eyes, throat, and nose. The machine
should always be used in a well ventilated room.
9. To avoid the dangers of fire and electrical shock, make sure that the machine is never
exposed to:
Excessive high temperatures and/or humidity
Dust
Water
Direct sunlight
Open flame
Corrosive gases
Trademarks
Microsoft®, Windows®, and MS-DOS® are registered trademarks of Microsoft
Corporation in the United States and /or other countries.
®
PostScript is a registered trademark of Adobe Systems, Incorporated.
®
PCL is a registered trademark of Hewlett-Packard Company.
®
Ethernet is a registered trademark of Xerox Corporation.
®
PowerPC is a registered trademark of International Business Machines Corporation.
Other product names used herein are for identification purposes only and may be
trademarks of their respective companies. We disclaim any and all rights involved with
those marks.