Ford 2003 Mustang Workshop Manual page 3029

SECTION 310-03: Speed Control
REMOVAL AND INSTALLATION
Actuator —Speed Control Servo
1. CAUTION: Electronic modules are sensitive to static electrical charges. If exposed
to these charges, damage may result.
Disconnect the battery ground cable.
2. Remove the LH wheel and tire; refer to
3. Position aside the LH front splash shield.
1. Remove the pin-type retainers.
2. Remove the screws.
3. Position aside the LH front splash shield.
4. Disconnect the speed control servo electrical connector.
5. Depress the locking tab and rotate the speed control actuator cable cap to remove.
2003 Mustang Workshop Manual
Section 204-04 .