SECTION 310-02: Acceleration Control
REMOVAL AND INSTALLATION
Accelerator Cable —3.8L
Removal and Installation
1. Push the accelerator cable nylon bushing out of the accelerator pedal and shaft arm.
2. Remove the bolts retaining the accelerator cable to the dash panel.
3. Disconnect the accelerator cable from the throttle body by rotating the throttle body full open
and aligning the cable with the release slot.
4. Disconnect the accelerator cable from the retaining bracket by compressing the locking tabs
and back-feeding the cable through the bracket and out of the engine compartment.
5. To install, reverse the removal procedure.
2003 Mustang Workshop Manual