Ford 2003 Mustang Workshop Manual page 3002

SECTION 310-02: Acceleration Control
REMOVAL AND INSTALLATION
Accelerator Cable Bracket —3.8L
Removal and Installation
1. Disconnect the speed control cable from the throttle body and the bracket. For additional
information, refer to
2. Disconnect the accelerator cable from the throttle body by rotating the throttle body full open
and aligning the cable with the release slot.
3. Compress the accelerator cable locking tabs and disconnect the accelerator cable from the
accelerator cable bracket.
4. Remove the bolts and the accelerator cable bracket.
5. To install, reverse the removal procedure.
Section 310-03 .
2003 Mustang Workshop Manual