Table of Contents
Advertisement
22
C
2: I
HAPTER
NSTALLING AND
Verifying the
Installation
Accessing the Web
Interface
C
A
ONNECTING THE
If you have an 802.3af-compliant power sourcing equipment (PSE), do
the following:
1 Connect one end of a standard Ethernet cable to the Ethernet port on the
back panel of the Access Point. And then, connect the other end to the
P+DATA port on the PSE.
2 Connect another Ethernet cable to the DATA IN port on the PSE, and
then connect the other end to a router, switch, or a computer.
3 Power on the PSE.
Figure 9 Powering the Access Point Using PoE
To verify that the Access Point has been successfully installed, check the
LEDs on the front panel.
The Status LED should flash, and then go off.
■
The Power, Wireless, and LAN LEDs should be on.
■
The Access Point provides an intuitive Web browser-based interface that
you use to configure the device. You connect to this interface using the IP
address that is assigned to the device.
When connected to a network that has a DHCP server, the Access Point
functions as a DHCP client, obtaining an IP address automatically from
the DHCP server. Therefore the IP address to which you need to connect
will depend on whether or not you have a DHCP server on the network.
By default, wireless connection to the Web interface is disabled. The first
time you configure the Access Point, you need to connect to its Web
interface using the wired LAN.
P
CCESS
OINT
Hide quick links:
Advertisement
Table of Contents
