TOHATSU EverRun MX 18E2 Service Manual page 292

Lower Unit
1
F
N
1342 1342
1342
"UL" Transom Model
A
5 5
6-52
TEF
TEF
2
OBM OBM
OBM
TEF
TEF
2
4 4
3 3
34) Installation of Lower Unit
1. Tilt-up outboard motor and lock with tilt stopper.
Set cam rod 1 to up position.
2.
· Apply thin coat of Teflon grease to spline of drive
shaft before assembling.
· Apply thin coat of OBM grease to water pipe seal
rubber.
· Lower unit installation can be made easier with
the outboard motor tilted up.
· When installing the lower unit, insert water pipe
into seal rubber properly.
TEF
TEF
OBM
OBM OBM
3. Put lower unit ass'y into drive shaft housing.
Connect and align positions of water pipe and water pipe
seal 2.
Move flywheel clockwise if necessary to align
crank splines.
4. Tighten lower unit ass'y installation bolts and nut to
specified torque.
13 N · m (9 lb · ft) [1.3 kgf · m]
1342
1342 1342
Connect shift rod joint 3 and shift rod 4, and drive in
5.
spring pin.
· Do not reuse spring pin.
· Replace with new one when removed.
Spring Pin Tool A 5 : (ø3.0)
P/N. 345-72227-0
GB
2st X18E2 2012