TOHATSU EverRun MX 18E2 Service Manual page 220

Power Unit
518
518 518
a a
'
#
"
&
5-68
26) Assembling Crank Ass'y and Crank
Case
1. Degrease crank case and cylinder mating faces.
2. Apply sealing agent to crank case's mating surface.
518 518
518 518
3. When installing crank case, check position of dowel pins
a.
a a
4. Install crank case to cylinder.
5. Tighten crank case securing bolts and nuts (M8)
$
in the order of the numbers shown.
!
%
Crank Case Mating Surface :
Loctite #518
· Be careful not to allow sealing agent to squeeze
out.
· Apply sealing agent on the area inside of the bolt
holes continuously in width of approximately 1
mm as shown.
518
Before securing with bolts, fit crank case snugly to
the cylinder by tapping with a plastic hammer to
make the gap between surfaces surfaces even.
Temporary Tightening :
12 N·m (9 lb · ft) [1.2 kgf · m]
Final Tightening :
25 N·m (18 lb · ft) [2.5 kgf · m]
Make no forced assemblies, rotate crankshaft with
flywheel after torquing crankcase bolts to ensure
nothing binding.
Tighten crank case securing bolts in two steps to
their specified torque.
GB
to
1 10
2st X18E2 2012