TOHATSU EverRun MX 18E2 Service Manual page 236

Power Unit
LIT
LIT
LIT
LIT
b b
2 2
1 1
c c
5-84
38) Assembling of Recoil Starter
1
2
a a
d d
Reverse disassembly procedure to assemble by taking care
of the following matters.
●Apply grease to parts as shown enough.
●When setting new starter spring 1 into starter case, face
starter spring inner edge hook a to the right and set it into
projection b of starter case.
Since newly delivered starter spring is bound by wire, cut
the wire to release the tension after setting inner end hook
in the case.
●When reinstalling starter spring 1 as same into starter
case 2, wind starter spring by hand, then put it into starter
case as shown.
●When attaching reel to starter case, put starter spring outer
end hook c in the pin d of reel.
●Apply cold resistance lithium grease to the following parts.
· Starter Spring
· Reel Center Hole
· Ratchet
· Starter Lock
· Friction Plate
LIT
LIT
GB
2st X18E2 2012